CUHK
News Centre

17 May 2022

CUHK Engineering develops new redox flow batteries for extreme cold weather

17 May 2022
Share
Print

Professor Yi-Chun Lu, CUHK Department of Mechanical and Automation Engineering

The first-author Mr. Fei Ai (Ph.D. student) showing the prototype of the HPOM based redox flow batteries at 25℃.

The prototype of the HPOM based redox flow batteries at 25℃ (left) and –20℃ (middle) and in the refrigerator (right). Water (H2O) is provided for reference.

Design principles of HPOM based redox flow batteries for low-temperature applications. HPOM electrolyte exhibits i) multi-electron reactions with fast redox kinetics; ii) a low freezing point down to –35℃; iii) high ionic conductivity; iv) high solubility of redox active materials.

A research team led by Professor Yi-Chun Lu, Associate Professor, Department of Mechanical and Automation Engineering at The Chinese University of Hong Kong’s (CUHK) Faculty of Engineering, has successfully developed a new electrolyte that enables high power, long life flow battery applications at both room temperature and low temperatures down to –20℃. The new flow battery achieves a high power density of 282.4 mW cm-2 and stability over 800 cycles (more than 1,200 hours) without decay at –20℃. This work enables high power, long life redox flow batteries to be used in regions with cold weather or severe weather fluctuations, a significant step towards the practical application of redox flow batteries for grid-scale storage of renewable energy. The breakthrough has been recently published in Nature Energy, one of the world’s leading scientific journals.

The low temperature issue facing conventional redox flow batteries

Aqueous redox flow batteries are a promising technology for safe, long duration energy storage and are key to achieving massive utilisation of intermittent renewable energies such as solar and wind power. However, at temperatures below freezing, redox flow batteries cannot be used because of the freezing of aqueous electrolytes, low reaction rate and the limited solubility of active materials. These challenges not only preclude the use of redox flow batteries in cold weather regions but also make renewable electrical grids extremely vulnerable to severe weather fluctuations. For instance, the recent power failure in Texas caused by a devastating snowstorm affected many millions of people, highlighted the need for a more robust electrical grid and energy storage over a wide range of working temperatures.

The state-of-the-art vanadium redox flow batteries suffer from lower solubility and lower redox kinetics at decreasing temperatures. Therefore, most commercial redox flow batteries need to use expensive, energy-consuming heating systems for low temperature applications.

H6P2W18O62 based redox flow batteries enable record stability and power density at low temperatures

Professor Lu and her team describe a new active material, multi-electron heteropoly acid H6P2W18O62 (HPOM), which enables high power, long life aqueous redox flow batteries below freezing. The HPOM exhibits a low freezing point (–35℃) and a high conductivity (74.32 mS cm–1 (–20℃)), which makes it an ideal active material candidate for high-power-density flow battery application at low temperatures.

The new HPOM based redox flow batteries demonstrated a high capacity, record stability (more than 1,200 hours without decay) and power density (282.4 mW cm–2) at a low temperature of –20℃, which makes them the first high-power low-temperature redox flow batteries with industrially relevant cycling stability.

Professor Lu said, “This work opens extensive opportunities to develop large-scale energy storage for extreme cold weather regions that was not possible before. The discovery also holds significant potential for the development of high power, stable redox batteries to come into play. The next important step is large-scale prototype demonstration for further development towards commercialisation.”

The full research paper can be found at: https://doi.org/10.1038/s41560-022-01011-y        



Professor Yi-Chun Lu, CUHK Department of Mechanical and Automation Engineering

Professor Yi-Chun Lu, CUHK Department of Mechanical and Automation Engineering

 

The first-author Mr. Fei Ai (Ph.D. student) showing the prototype of the HPOM based redox flow batteries at 25℃.

The first-author Mr. Fei Ai (Ph.D. student) showing the prototype of the HPOM based redox flow batteries at 25℃.

 

The prototype of the HPOM based redox flow batteries at 25℃ (left) and –20℃ (middle) and in the refrigerator (right). Water (H2O) is provided for reference.

The prototype of the HPOM based redox flow batteries at 25℃ (left) and –20℃ (middle) and in the refrigerator (right). Water (H2O) is provided for reference.

 

Design principles of HPOM based redox flow batteries for low-temperature applications. HPOM electrolyte exhibits i) multi-electron reactions with fast redox kinetics; ii) a low freezing point down to –35℃; iii) high ionic conductivity; iv) high solubility of redox active materials.

Design principles of HPOM based redox flow batteries for low-temperature applications. HPOM electrolyte exhibits i) multi-electron reactions with fast redox kinetics; ii) a low freezing point down to –35℃; iii) high ionic conductivity; iv) high solubility of redox active materials.

 

Download all photos